1973 Mercury Cougar

Plastic housings with brass nozzles. Note that you may need to adjust the nozzles to achieve the desired aim.

This is a replica white plastic washer bottle / reservoir with black top & cap (D1TZ-17632-A)

Injection molded high strength plastic connector for hoses leading to nozzles.Correct squared press-in fitting

Original driver side (left hand) wiper arm pulled from a 71 - 73 mercury Cougar. Includes snap clip to hold the second arm in place. Replaces Ford part #: D1ZZ-17526-B. Note: 1971 model year through 11/15/1970 uses the same wiper arm on both sides, which is the one used on the passenger side in the late 71 - 73 Cougars (Part #: D1ZZ-17526-A).

Original passenger side (right hand) wiper arm pulled off a 71 - 73 Mercury Cougar. Replaces Ford part #: D1ZZ-17526-A. Note: 1971 model year through 11/15/1970 uses the same wiper arm on both sides, which is the one used on the passenger side in the late 71 - 73 Cougars (Ford part #: D1ZZ-17526-A).

Reproduction wiper arms for the 71 - 73 Cougar or Mustang. Sold as a pair.Replaces For Part number D1ZZ-17526-B

Original black windshield wiper blade holder. Fits any 1971-73 Mercury Cougar or Ford Mustang. Sold individually, two per car, 18" rubber wiper blade not included.Replaces Ford part #: D1AZ-17528-C or D3AZ-17528-A.

The hinges on these original arms tend to get worn out which will cause irregular movement and can eventually burn up your wiper motor or bind up the linkage. If your wipers do not move in tandem

Original FoMoCo used two speed windshield wiper motor for your 1971-73 Mercury Cougar or Ford Mustang. This used motor comes with wiring harness, for all 1971-73 Cougar and Mustangs. Motors are tested and guaranteed to work, 90 day warranty. Linkage arm for the 1971-73 installation, must be marked 1Z. Linkage arms sold separately. Ford part #s D1ZF-17504, D2ZF-17504, D1ZZ-17508-A

A nice reproduction of the standard air cleaner wing nut. This version was used on most Ford products through the 1980's.

Spare Tire Mount Wing Nut Reproduction for the 1968 through 1973 Mercury Cougar / Ford Mustang

For 1968 Ford standardized or changed all of the J-bolt threads to the beefier 1/2"-13. We have noted two variations of this wing nut. The most obvious identifier between the two is the tabs in the center. The majority have these tabs present, the minority do not. We also stock and carry the correct disc or hold down plate, and the J bolt. Lots of sizes and lengths for those. Do you have the correct one?

Replaces Ford part #D1ZZ-17430.

Nice reproduction of the D0OZ-17C583-A windshield wiper stop as found on any 1971-73 Mercury Cougar, 1971-73 Ford Mustang, 1970-71 Ford Torino, or 1970-71 Mercury Cyclone. Zinc plated and rubber dipped like OEM Ford.Replaces Ford part number D0OZ-17C583-A.

Master clip kit which includes the following fasters:Back up light to firewallDoor speakersEngine ffeedRadio cable to dashSide marker and headlightsTaillight wiring and groundUnder dashVarious location zip tiesKeep in mind that not all fasteners found on 1971-73 Cougars / Mustangs are in this kit.

Used wire harness with diffusers for the instrument cluster lighting (dash lights) on the Standard or XR7 71 - 73 Mercury Cougar.  NOTE* When using LED ground sensitive bulbs, you must reverse the black and blue w/red stripe wires. Ford part number D1WB-10B898-AA

Used lead wire harness that runs from the white plug at the cowl to the throttle positioning sensor on the 71 - 73 Cougar or Mustang.Harness is red with yellow hash marks.

Small retaining ring that secures the engine gauge feed wiring harness to the driver side valve cover. Two were used per engine. We found this part in the 1971-72 Mustang Electrical Assembly Manual. To be used with original wiring harnesses, the reproduction engine gauge feed harness does not have the clips to attach to this retainer.Ford part number D2AB-14A163-MA.

Wiring harness segment from firewall to the convertible power top switch on any 1971-73 Mercury Cougar or Ford Mustang.  Part number D1WB-15A690-AA.

Preproduction wiring harness, connects the convertible top switch to the pump on both the xr7 and standard model Cougars and Mustang 1969 - 1973 convertibles.

This harness connects the convertible top switch to the pump on both the xr7 and standard 1969 - 1973 convertibles.

Wiring harness segment to the convertible power top pump on any 1971-73 Mercury Cougar or Ford Mustang. Part number D1ZB-15A668-AB.

Used wiring harness that runs from the A/C switch to the reisistor harness. Harness plugs into the blower switch and runs to the resistor box and de-icing switch.For part number D3ZB-19C603

Used wiring harness that goes into the shifter bucket for any 1971-73 Mercury Cougar or Ford Mustang with C6 transmission. This is for the PRNDL light on your shift lever. Automatic C-6 transmission only code U on your door tag. FMX transmissions had the neutral safety switch installed in the shift bucket. Rare part, only found on Q code engines and select H code engines. D1ZZ-15A808-A, D1ZB-15A808-AB, D2ZB-15A808-AA This icon means that we're looking to buy this part!WCCC is a buyer of used...

Wiring harness under hood segment from circuit breaker through the firewall to the convertible power top switch on any 1971-73 Mercury Cougar or Ford Mustang.  Part number D1ZB-15A669-A.

Used heater control light wiring harness for the 72 - 73 Cougar with A/C.

Used rear defog wiring harness for any Standard Model 1973 Mercury Cougar. Non-XR7 models only, this harness is the main under dash harness that plugs into the back light glass or defog switch. This listing does not include the jumper wiring harness to the heated back glass, or the relay.Ford part number D3WB-18C617-BA.

Used rear defog wiring harness for any XR7 model 1973 Mercury Cougar. XR7 models only, this harness is the main under dash harness that plugs into the back light glass or defog switch. This listing does not include the jumper wiring harness to the heated back glass, or the relay.*Note - Does not fit Standard Model Cougars, those have a different plug for the switch.Ford part number D3WB-18C617-AA.

Used jumper wire for connecting the heated back lite glass to the defog harness on any 1973 Mercury Cougar or Ford Mustang equipped with factory rear defogger. AKA defrost. 1971-72 has a different wire connector.Ford part number found on wiring diagram 18C394.

Factory used and tested under dash wiring harness for all 1972-73 Mercury Cougar and Ford Mustang cars with factory AM/FM or AM 8 Track stereo radios. This harness plugs into the speaker plug of the radio, and connects the door panel wiring harness with door speaker option in a 1972-73 Mercury Cougar or to the A pillar post where it connects to the door wiring harness that has the speaker plug for the door mounted speakers in 1972-73 cars. White speaker wire goes to the passenger side speaker,...

Used driver side turn signal / parking lamp wiring harness with socket for the 1971 - 1973 Mercury Cougar.Ford part number D2WB-13234-AA

Used passenger side turn signal / parking lamp wiring harness with socket for the 1971 - 1973 Mercury Cougar.Ford part number D2WB-13235-AA

Consolette wiring harness, bridges the main under dash wiring harness and the ashtray light pigtail. Not for full length consoles. Ford part # D1WB-15A056-AB.

Original used speaker lead wiring harness pigtail for all 71 - 73 Cougars and Mustangs with factory AM radios. This wire pigtail is located in the dash. Proper length for re-soldering to factory dash speaker.

Used back up light socket and wiring pigtail for the 71 - 73 Cougar.

Original used AM radio dash speaker wiring plug and pigtail. We like to use these original plug and wiring bits to keep from cutting an otherwise perfect radio harness. Use it on your modern replacement dash speaker and plug into your factory AM radio. Wire colors and striping are unique to the 1973 model year.

New wiring pigtail with male bullet connector, and male / female paired connector. Also has rubber grommet that fits a 5/8" inch hole. Looks like 18 gauge wiring. These are remnants from the reproduction Mustang front turn signal lights that we convert to Cougar wiring. Brand new, approximately 13-15 inches in total length. Colors as shown.

This pigtail is for 72-73 Mercury Cougar and Ford Mustang with stereo speakers. Original driver side used under dash speaker wiring harness pigtail for all 1972-73 Mercury Cougar and Ford Mustang cars with factory AM/FM or AM 8 Track stereo radios. This speaker wiring harness pigtail plug end goes to the your driver side speaker, which is denoted by the orange wire.

This pigtail is for 72-73 Mercury Cougar and Ford Mustang with stereo speakers. Original passenger side used under dash speaker wiring harness pigtail for all 1972-73 Mercury Cougar and Ford Mustang cars with factory AM/FM or AM 8 Track stereo radios. This speaker wiring harness pigtail plug end goes to the your passenger side speaker, which is denoted by the white wire.

Used wiring pigtail that runs from the 14401 under dash wiring harness from the tach to the fuse block and connector (green block behind fuse box) to the under hood harness on the 71 - 73 XR7 Cougar. 

Used wiring pigtail that runs from the taillight harness to the ground at the fuel filler bracket on the 71 - 73 Cougar Standard or XR7 models.

Used wiring pigtail that runs from the taillight harness to the sequential box on the 72 - 73 Cougar STD or XR7 

Used wiring pigtail that runs from the taillight harness to the sequential unit on the 71 - 73 Cougar STD / XR7

Used wiring pigtail that runs from the taillight harness to the side marker light on either the driver or passenger side of the 72 - 73 Cougar Standard or XR7 model.

Used wiring pigtail plug that runs from the taillight harness to the Driver side taillight housing and the 71 - 73 Mercury Cougar Standard or XR7

Used wiring pigtail plug that runs from the taillight harness to the passenger side taillight housing and the 71 - 73 Mercury Cougar Standard or XR7

Used wiring pigtail for the taillight harness that connects to the under dash harness at the driver side kick panel for the 71 - 73 Cougar Standard or XR7. This is the red plug pigtail. We also list the white plug pigtail.

Used wiring pigtail for the taillight harness that connects to the under dash harness at the driver side kick panel for the 71 - 73 Cougar Standard or XR7. This is the white plug pigtail. We also list the red plug pigtail.