Your cart is empty!
Our shopping cart requires the use of cookies. If you have your cookies disabled, please enable them for our site to place an order. If you have cookies enabled and have added an item to your cart, but you are still seeing this message, that could indicate that the cookie for our shopping cart is corrupted on your computer.You should be able to fix this by either:
Looks great combined with the tower clamps. Had to trim 1/4" off the end that goes onto the water pump as it seemed slightly too long. Otherwise perfect.
Hoser, clamp...DONE
It works great after cutting. I just want to say that I don't know why this is reproduced with the Autolite stamp. I may be wrong, but I believe these were installed prior to painting the engine, so the hose and both clamps should be painted. Correct? WCCC Response:The Bypass hose would never have been entirely painted from the Factory. Most examples we have seen with Over-spray are from engine repaints.
It works great after cutting. I just want to say that I don't know why this is reproduced with the Autolite stamp. I may be wrong, but I believe these were installed prior to painting the engine, so the hose and both clamps should be painted. Correct?
WCCC Response:The Bypass hose would never have been entirely painted from the Factory. Most examples we have seen with Over-spray are from engine repaints.
Quality part. Need to adjust to fit. Look the Ford printed part number however the printing rubs out very easy. I applied a clear coat to help preserve the hose printing.