1967 Mercury Cougar

Used under dash wiring harness repair plug and pigtail to the instrument panel on the Mercury Cougar Standard. The wires can be removed and the bare plug can be purchased separately. This is part of the 14401 main under dash wiring harness. 

Used under dash wiring harness repair plug and pigtail to the windshield wiper switch for the Mercury Cougar. The individual wires can be removed and the bare plug can also be purchased separately. This is part of the 14401 main under dash wiring harness.

Used under dash wiring harness repair plug and pigtail for the turn signal indicator relay on your Mercury Cougar. This is part of the 14401 main under dash wiring harness.**NOTE** Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state sequential systems. There is no question he cannot answer! Here is a link to a great source of information...

Used under dash wiring harness repair plug and pigtail to the turn signal relay for your Mercury Cougar. This is part of the 14401 main under dash wiring harness. Early version is identified by the double purple wire on the end, later 1967 versions have only one purple wire.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars since the 1970's and is the designer of all of our solid state...

Used under dash wiring harness repair plug and pigtail to the turn signal relay for your Mercury Cougar. This is part of the 14401 main under dash wiring harness. This late version has a single purple wire in the end plug position. Early version is identified by the double purple wire on the end, We do not know the approximate cutoff date.*NOTE* Need help diagnosing a Cougar turn signal problem? Victor Yarberry is the world’s most knowledgeable expert on the subject. Vic has owned Cougars...

Used under dash wiring harness repair plug and pigtail to the turn signal switch for the Mercury Cougar. This unit comes with an in-line fuse cartridge, the wires can be removed, and the bare plug can also be purchased separately. This is part of the 14401 main under dash wiring harness. We also have the mate to this harness, the turn signal to under dash pigtail.*NOTE* The wires on the plug can be removed. The bare individual plug can also be purchased separately.**NOTE** Need help diagnosing...

Used under dash wiring harness repair plug and pigtail to the wiper coordination switch (foot pump/washer) for the Mercury Cougar. This is part of the 14401 main under dash wiring harness.*NOTE* The individual wires can be removed and the block is also available without the wiring pigtail.

Used under dash wiring harenss repair plug and pigtail to the wiper motor for the Mercury Cougar. This is part of the 14401 main under dash wiring harness. We also carry the mate for this pigtail. You can check wire colors for correct pigtail.

Reproduction under hood wiring harness repair plugs and leads that go from the under hood harness to the starter solenoid on the Mercury Cougar or Ford Mustang.  Sold as a pair.

Used wiring pigtail that runs from the 14290 under hood harness to ground from the alternator / lights.

Used plug and wiring pigtail for the brake light warning switch located on the drum or disc brake distribution block mounted to the driver side fender apron. This is a plug and section of wire for repairing the underhood harness. Unique rubber sealed plug, 1967 single pin only. Violet colored wire. Fits 1967 Mercury Cougar and Ford Mustangs.

Used wiring pigtail that runs from the under hood harness pigtail to the driver side headlight harness (brown plug) on the 67 - 68 Standard or XR7 model Cougar.

Used wiring pigtail that runs from the 14209 under hood harness to the driver side horn.

Used wiring pigtail that runs from the under hood harness to the driver side turn signal harness on the 67 - 68 Cougar Standard and XR7 models.

Used wiring pigtail that runs from the under hood harness to the front turn signal / headlight solenoid and starter solenoid on the 67 Standard and XR7 Cougars. Located above the driver side kick panel behind the heater controls.

Used wiring pigtail that runs from the under hood harness to the headlight solenoid on the 67 Standard and XR7 model Cougars.

Used wiring pigtail that runs from the under hood harness to the horn / voltage regulator / starter solenoid on the 67 - 68 Standard and XR7 model Cougars. Located above the driver side kick panel behind the heater controls. 

Used wiring pigtail that runs from the under hood harness to the driver side headlight harness on the 67 - 68 Cougar.

Used wiring pigtail that runs from the 14209 under hood harness to the passenger side horn.

Used wiring pigtail that runs from the 14290 under hood harness to the right hand (passenger) side park / turn signal. 

Used wiring pigtail that runs from the under hood harness to the small post on the starter side of the starter relay on the 67 - 68 Standard and XR7 model Cougars. 

Used wiring harness that runs from the 14290 under hood harness to the voltage regulator on the 67 - 68 Standard Cougar.

Used wiring pigtail which is part of the 14290 under hood harness and runs from the battery side of the starter relay to the voltage regulator (yellow) and the fuse box (black/yellow).

Used wiring harness that runs from the 14290 under hood harness to the voltage regulator on the 67 - 68 XR7 Cougar.

Used wiring pigtail that runs from the under hood harness to the voltage regulator from the alternator harness on the 67 - 68 Standard model Cougars.

Used wiring pigtail that runs from the under hood harness to the voltage regulator from the alternator harness on the 67 - 68 Standard and XR7 model Cougars.

Used wiring pigtail that runs from the under hood harness to the voltage regulator from the ignition switch on the 67 - 68 Standard and XR7 model Cougars.

Used wiring pigtail that runs from the under hood harness to the voltage regulator from the starter solenoid on the 67 - 68 Standard and XR7 model Cougars.

Used wiring pigtail that runs from the under hood harness to the voltage regulator ground bolt on the 67-68 Standard and XR7 model Cougars.

Used pigtail that runs from the main 14401 harness to the console courtesy light (blue plug) on your 67 - 68 standard Cougar.

Used wiring pigtail that runs from the 14401 main wiring harness to the PRNDL light (red plug) on your standard 67 - 68 Cougar.

Used wiring pigtail that runs from the 14401 main wiring harness to the tachometer on your 67 XR7 Cougar.

Used wiring pigtail that runs from the main under hood harness to the headlight harness, parking light harness and differential switch. Located above the left hand (driver side) kick panel behind the heater controls.

Used under dash wiring harness repair plug and pigtail from the wiper motor to the main 14401 harness for the Mercury Cougar. We also carry the mate for this pigtail. You can check wire colors for correct pigtail.

Reproduction wiring pigtail repair kit for the sequential box on the EARLY 1967 Cougar. Keep in mind that early and late 67's used different plugs, so be sure to order the right version. Included are: 1 six pin connector1 eight pin connector2 four pin connectors

Reproduction wiring pigtail repair kit for the sequential box on the LATE 1967 Cougar. Keep in mind that early and late 67's used different plugs, so be sure to order the right version. Included are: 1 six pin connector1 eight pin connector1 four pin connector

Used under dash wiring harness repair bare ignition switch plug for the Mercury Cougar. This is the plug only, no wiring pigtail, and is part of the 14401 main under dash wiring harness.

Correct plug for your 67-71 AM- FM radio, or 8-track... Often these have been cut from the main loom to install an after market radio.The 1972 model used the same plug, but the wires are not in the same spots, go figure! These are speaker wires not power wires.The color codes are:  White right cowl speaker.   Orange left cowl speaker. Speaker blue / black ground. Power "not this listing." Blue / red stripe, radio light. Yellow / black stripe, power in for radio. ...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

The Wittek Company manufactured the tower clamps used on the Cougar from 1967 to 1973, the Mustang from 1964 1/2 to 1973, as well as many other Ford and Mercury cars during that period. In October or 1993, the company filed for bankruptcy. This has made the tower clamp unavailable to the classic car restorer. Our supplier was able to bid at the auction for enough of the original tooling and parts to make these clamps available again. Other companies have also reproduced these clamps, but...

Reproduction wrench or crank, for manually closing the factory installed sunroof installed on any 1967-73 Mercury Cougar. Sunroofs, technically moonroofs, were originally installed by ASC or American Sunroof Corporation. Hertz 1968 XR7-G cars all came with factory sunroofs, as did the Hertz rental 1969-70 Cougar Eliminators. ASC also installed sunroofs in Ford Thunderbird, Lincoln MK III.ASC used Golde mechanical parts from Germany. Golde was a manufacturer of sliding canvas and metal roofs on...